Sliding door and window repair, done to last in South Florida
Salt air, wind-blown sand and 90-degree humidity destroy sliding hardware faster here than anywhere else. Each service below is specified for coastal conditions in Miami-Dade and Broward.
Seized, flat-spotted or salt-corroded rollers are the #1 reason a sliding glass door drags. We install heavy-duty tandem steel rollers rated for coastal humidity.
Tandem stainless rollers
Panel lift & re-hang
Height & pitch calibration
Track Repair & Stainless Track Caps
Bent, pitted or sand-packed bottom tracks chew through new rollers in months. We straighten, deep-clean or cap the track so the door glides for years.
Track straightening
Stainless cap-over install
Deep debris extraction
Locks, Latches & Handle Sets
Broken mortise locks, loose keepers and snapped handles leave your home unsecured. We match hardware to your frame profile and set the strike properly.
Keyed & thumb-latch locks
Mortise lock swap
Secondary security bars
Sliding Screen Doors & Rescreening
New screen frames built to your opening, or fresh mesh in your existing frame — including pet-resistant and no-see-um mesh for South Florida evenings.
Custom-built screen frames
Pet & no-see-um mesh
Screen roller & guide kits
Sliding Window Repair
Horizontal sliders that stick, drop out of the track or refuse to lock. We rebuild the operating sash, replace guides and restore smooth one-finger travel.
Sash guides & rollers
Window latch replacement
Balance & frame squaring
Alignment & Adjustment Tune-Up
Doors that rub the jamb, bind at the lock or let daylight through are usually out of plumb. A precision tune-up fixes drag without new parts.
Plumb & square check
Roller height balancing
Lock engagement reset
Weather Seals & Storm Prep
Brittle weatherstripping means wind noise, wind-driven rain and AC dollars pushed outside. We re-seal jambs, interlocks and brush sweeps.
Jamb & interlock seals
Brush sweeps
Water intrusion checks
Replacement Hardware & Glass Panels
Discontinued rollers, guides, keepers, pulls and stiles sourced and fitted. When a panel is beyond saving, we handle full panel replacement.
Hard-to-find parts sourcing
Panel & stile replacement
Glass unit swap-out
Signs your sliding door needs service now
Catching these early usually means a roller-and-track repair instead of a full panel replacement.
Takes two hands or a shoulder to open
Grinding, popping or scraping along the track
Panel lifts or jumps out of the track
Lock won't engage without lifting the door
Daylight or drafts visible at the jamb
Water reaches the tile during heavy rain
Screen mesh torn or frame pulled apart
Wheels visibly flat, rusted or missing
Door rubs the frame at the top corner
Not sure which repair you need?
Describe the symptom in the assistant and we'll tell you what to expect — or call 305-360-0342.
